The E-30-PT is to provide quick and reliable communication in noisier areas. The mic sensitivity is set to a low level until the TALK button is pressed then it is raised to a normal level. In this way, the E-30-PT assures that the called party’s voice will be broadcast over the speaker. In areas where the background noise can be louder than the person calling, a handset type phone is recommended.

Features:

• Push to talk button
• Phone line powered
• Vandal resistant, stainless steel faceplate with heavy-
• duty metal call button
• Non-volatile E2 memory (no batteries required)
• Touch Tone or pulse dialing
• Programmable to dial up to 5 numbers on busy or ring no answer
• Red off-hook LED indicator
• Hangs up on CPC, silence, busy signal, return to dial tone, time out or a Touch Tone command
• Programmable to auto-answer on incoming calls Remotely programmable
• Extended temperature range (-15°F to 130°F)
• E-30-PT-EWP has Enhanced Weather protection
• Flush mountable using included plastic rough-in box
• Optional VE-5x5 surface mount back box
• E-30-PT-EWP conforms to NEMA requirements

Specifications:

• Power: Telephone line powered (24VDC talk battery with 20mA loop current minimum)
• Minimum Ring Voltage: 90VAC RMS
• Dimensions: Overall-127mm x 127mm x 57mm (5” x 5” x 2.25”), Plastic Electrical Box-102mm x 102mm x 54mm (4” x 4” x 2.12”)
• Operating Temperature: -26°C to 54°C (-15°F to 130°F) Humidity - E-30-PT: 5% to 95% non-condensing Humidity - E-30-PT-EWP: Up to 100% condensing,/li>
• Connections - E-30-PT: RJ11 jack
• Connections - E-30-PT-EWP: Gel-filled butt connectors

Enhanced Weather Protection:

Includes weather-sealed trim pots and DIP switches, a special rubber microphone boot and a mylar speaker with a rubber gasket acting as a primary shield against water penetration. If required, face plate gaskets are provided to further eliminate water infiltration. All connections are hand soldered to eliminate corrosion, and the connections at the push button switch, microphone, and "Call Connected" LED are also hand sealed using a special non-corrosive electronics grade flexible silicone sealant. The entire circuit board is "potted" in a flexible urethane encapsulating material, leaving the weather sealed field-adjustable trim pots and DIP switches accessible for on-site programming. The flexible urethane sealant allows the circuit board and its components to expand and contract, while maintaining weather resistance. To protect the tip and ring connections, special connectors filled with anti-corrosive sealing gel are included.